• Concrete
• Asphalt
• Bricks
• Cladding
• Exterior Timber
• Metal Surfaces
• Weatherboard
• Render

• Key Benefits:
• • Fast-acting and easy to clean up
  • Reduces labour time and chemical waste
  • Safe on most painted, sealed, and masonry surfaces
  • Non-acidic, non-flammable, and non-hazardous
  • Cost-effective and efficient, reducing overall removal costs
  • Safe to store and transport, no special handling required
• Will not fog or streak Perspex, Laminex or glass
• Will not damage most underlying protective paints
• Fully Biodegradable
• Nonflammable
• Non-Hazardous
• Low odour
• Easy clean-up with running water
• Non-caustic – will not burn skin

Cost-Effective

Not only is Nu Ecosafe Strip – Graffiti Remover highly effective it is also a cost-effective solution that saves time and expense while also having a myriad of uses.

• Requires much less chemical to achieve desired results
• Reduces man-hours and effort required to complete a project
• Lowers insurance costs for worker safety and storage hazards
• Non-hazardous, unlike other acidic cleaners.

Preparation:

• Cover/protect areas where the paint is to be left on. This includes adjoining surfaces where over-spray may travel. Polyethylene sheets make a very effective barrier. If using masking tape, apply two layers of tape and remove the top layer immediately after application, as the remover may soak through the tape, damaging the paint under it. Plants should be covered or washed thoroughly with water before and during application.
• The product should not be diluted and must not be mixed before application.
• Remove all filters from the pump, sprayer and gun. Prime the pump and run the stripper through the hose and gun until all previous water/solvent/paint residue has been cleaned out.
• Always prepare a test area before completing the application. This will indicate the time required for project completion and the product’s suitability for the paint and substrate.

Application Guidelines

Apply an even layer of stripper onto the coating being removed. If using an airless sprayer, always start the pump at the lowest pressure setting and slowly build up the pressure until an adequate fan pattern has been generated to prevent overspray. Do not use on porous surfaces, e.g., Unpainted brick or concrete. For removing Graffiti off porous surfaces, use Nu-EcoSafe-Strip Industrial Paint Stripper.

The time required to remove or soften graffiti/overspray depends on the type of paint, number of paint layers and substrate temperature. Most graffiti/overspray will soften within 10 minutes. Do not let any application stay on for more than 15 minutes. If the job has not been completed, wipe off the softened graffiti/overspray with a cotton cloth and reapply the EcoSafe Strip Graffiti remover.

Coverage rate 3.7 to 5 sq. metre per Litre depending on surface.

Ambient and surface temperatures should be in the range of 20^oC to 32^oC. The product performs effectively at lower temperatures (even at 0^oC), but the dwell time increases.

For small areas, removal of residue can be completed by wiping with a dry cotton cloth, followed by a warm or soapy water rinse. For larger surfaces, removal can be accomplished by pressure washing at approximately 600 psi with fresh water.

Download EcoSafe Graffiti TDS
Download EcoSafe Graffiti SDS

This product may cause skin irritation. Wear protective equipment and refer to the Safety Data Sheet for more information.